Vector V08 Manual de usuario descargar pdf (Pagina 4)

INSTALLATION DIRECTIVE MAY 2006

V08 ENT M75

M11

M12

To obtain the best engine performance, it is essential not to

deviate from the mission profile for which it was produced

and set up. The engine must not be used for purposes other

than those stated by the manufacturer. IVECO MOTORS is

willing to examine any need for particular installations befo-

rehand. Use of an electronically controlled injection system,

in providing the engine with performance benefits, requires

that the installer and maintenance specialist comply with

some fundamental rules, which will become more and more

commonplace as use of such equipment becomes progressi-

vely more widespread. Boat outfitters and maintenance spe-

cialists are invited to closely follow the instructions contained

herein. No modifications to the engine, its accessories and

components, are allowed.

Failure to comply with the instructions that follow shall

void the warranty and relieve IVECO MOTORS of all

liabilities.

For personnel safety

Specialists and installers are cautioned to comply with

workplace safety rules and to adopt prescribed individual

protection devices when working.

o Drain the cooling, lubrication and fuel lines only after

the fluids have duly cooled. The pressurized cap of the

coolant line may be opened only after the engine has

duly cooled.

o Batteries contain a highly corrosive sulphuric acid solu-

tion: must never be upset and must be handled with

the utmost caution to prevent spillage. Ensure that the

battery compartment is adequately ventilated.

Handling

The engine must be handled by experienced personnel,

using the prescribed tool or a rocker arm that keeps the

lifting lines parallel and with adequate equipment in terms

of capacity and size. The two eyebolts provided for lifting the

engine alone must always be used simultaneously.

Installation

o Knife switches or battery breakers may be used on the

power supply line of the engine electronic unit, provided

they are not used to shut off the engine.

o Do not modify the wiring harnesses; their length may

not be modified: use only available extensions.

o Do not use electronic device wiring harnesses not com-

pliant with the IVECO MOTORS directive, in terms of

length, type of conductor, location, clamping, connection

of the shielding and earth braids.

o To avoid any interference, the wiring harnesses of the

different on-board electronic devices must follow diffe-

rent paths from those of the engine electronic systems.

o Do not connect any extraneous user device to the engi-

ne electrical equipment.

o Do not energize the on-board electrical system of the

boat without first verifying that there are no short cir-

cuits.

o Do not branch pipes off to draw fuel from the engine

supply lines.

o Do not make any change to the engine’s hydraulic circui-

ts and components.

o Do not execute arc welding operations before removing

the electronic units from their seating, placing them at an

adequate safety distance.

o Do not subject electronic units to temperatures excee-

ding 80°C.

o Do not paint electrical components and their connec-

tions.

o Do not alter the data contained in the engine control

electronic unit.

o Comply with prescribed procedures and torque values

when tightening threaded elements.

Start-up

o Ready the engine following the procedure set out in

Chapter 14.

o When starting the engine the first time, have suitable

means available to cut off air intake in case of a runaway

condition.

o Start the engine after ensuring that it is complete with

every part specified by the manufacturer and required

by the installation, without attempting to start it with

caps and occlusions to the lubrication, cooling and fuel

feed lines.

o Check that the fluid lines are perfectly sealed, especially

lines for fuels and lubricants, which may cause fires and

consequent harm to persons and equipment.

o Make sure that the various pipelines are not in contact

with warm surfaces or moving parts.

o The installing yard is required to carry out tests to

verify the functional compatibility between the electri-

cal-electronic equipment of the engine and the other

electronic equipment present on the boat.

Tests and tuning up

o Never disconnect the batteries when the engine is run-

ning.

o Remove the electrical connections from the batteries

before any operation on the electrical system.

o Ensure that the battery terminals comply with the exact

polarity, are properly tightened and protected against

accidental short circuits and corrosion phenomena.

1. WARNINGS AND CAUTIONS

1 2 3 4 5 6 7 8 9 ... 59 60

Comentarios a estos manuales

Sin comentarios

Jvc CS-V6942 Manuale Utente (2 pagine)

Marchio: Jvc | Categoria: Car speakers | Dimensione: 2.62 MB |

Indice

INSTRUCTIONS

Jvc CS-V6942 Manuale Utente (4 pagine)

Marchio: Jvc | Categoria: Car speakers | Dimensione: 2.19 MB |

Indice

CS-V6942

Óñòàíîâêà

Ïðàâèëà óñòàíîâêè è

Çàâåðøåíèå ïîäêëþ÷åíèÿ

Òåõíè÷åñêèå õàðàêòåðèñòèêè

Êîìïëåêò ïîñòàâêè

Più prodotti e manuali per Altoparlanti per auto JVC

Modelli	Tipo di Documento
CS-V6930	Manuale Utente Инструкция по эксплуатации JVC CS-V6930, 4 pagine
CS-V523	Manuale Utente Инструкция по эксплуатации JVC CS-V523, 4 pagine
GET0651-001A	Manuale Utente JVC GET0651-001A User Manual, 145 pagine
FSUN3121-T451 KD-S673R	Manuale Utente JVC FSUN3121-T451 KD-S673R Manual del usuario, 4 pagine
CS-V6 SERIES CS-V6936	Manuale Utente JVC CS-V6 SERIES CS-V6936 User Manual, 2 pagine
CS-FX502	Manuale Utente JVC CS-FX502 User Manual, 2 pagine
GET0570-002B	Manuale Utente JVC GET0570-002B User Manual, 4 pagine
GET0075-001A	Manuale Utente JVC GET0075-001A User Manual, 54 pagine
GET0642-002A	Manuale Utente JVC GET0642-002A User Manual, 2 pagine
EXAD LVT1373-001A	Manuale Utente JVC EXAD LVT1373-001A User Manual, 58 pagine
GET0139-001A	Manuale Utente JVC GET0139-001A User Manual, 33 pagine
KD-AR7000	Manuale Utente JVC KD-AR7000 User Manual, 153 pagine
GET0260-003B	Manuale Utente JVC GET0260-003B User Manual, 64 pagine
KD-DV6102	Manuale Utente JVC KD-DV6102 User Manual, 68 pagine
KD-G720	Manuale Utente JVC KD-G720 User Manual, 256 pagine
CH-X350/X300	Manuale Utente JVC CH-X350/X300 User Manual, 6 pagine
LVT1055-001A	Manuale Utente JVC LVT1055-001A User Manual, 80 pagine
Model KD-S10J	Manuale Utente JVC Model KD-S10J User Manual, 59 pagine
KD-G400	Manuale Utente JVC KD-G400 User Manual, 42 pagine
DIGITAL AUDIO KD-S550	Manuale Utente JVC DIGITAL AUDIO KD-S550 User Manual, 94 pagine

Vector V08 Manual de usuario Pagina 4

Comentarios a estos manuales

JVC CS-V6942 manuali

Jvc CS-V6942 Manuale Utente (2 pagine)

Indice

Jvc CS-V6942 Manuale Utente (4 pagine)

Indice

Più prodotti e manuali per Altoparlanti per auto JVC